top of page

TIPS'n'TRICKS

Setting the 3D elements

  • 3D of a layer is created by making it translate from left to right or in opposite direction.

  • When the 3D is increased the layer crosses more lenses (moves move)

  • The more 3D you apply to a layer the fuzzier it will appear

Choosing the lens

  • High LPI frequency will give you a High Definition image.

  • High LPI frequency is better for small images seen from close.

  • Low LPI frequency will give you a Big 3D.

  • Low LPI frequency is better for large images seen from a distance.

  • High LPI frequency focusing on a THICK substrate will take no time to print.

  • Low LPI frequency focusing on a THIN substrate will take more time to print.

Printing and registration

  • Angle registration is very important. You need to registrate on the same side of the substrate to keep the angle right.

  • Dust or dirt can cause poor adhesion of the lens.

  • Only transparent substrate of the correct thickness should be used.

Please reload

bottom of page